LS280 is used to measure optical maintenance factor for high power LEDs, LED module, LED bulb or other LED luminaries. It is the important measuring equipment for performing the reliability of illuminants.

Measure:
Illuminance Maintenance curve, factor and data: lx VS time
Luminous Intensity

Electrostatic discharge simulator (electrostatic gun) ESD61000-2 in full compliance with IEC 61000-4-2, EN61000-4-2 and GB/T17626.2 standards, the ESD generator for the assessment of electrical and electronic equipment to withstand ESD performance to develop a common criteria, the technology has

JL-X waterproof test system is according to IEC60529, IEC60598, IEC60335 and IEC 60034-5:2000. The JL-X includes the following test grades: IPX1, IPX2, IPX3, IPX4, IPX5, IPX6, IPX7 and IPX8 (Refer to page 51 of IEC60529). It is widely used in the authentication test organization for the products

• Purpose: According to IEC 60068, this product is applicable for the testing of the indices of the spaceflight and aviation products, information electronic instruments and meters, materials, electrical and electronic products and electronic and electrical components and parts in high-temperature

LSG-1800 Goniophotometric system is an automatic goniophotometric measurement system for measuring photometric parameters of luminaires, such as LED road lighting fixture, room lighting fixture and projecting lighting fixture. The measured data meets IES standard format and can be applied for

LPCE-1 Spectrophotometer & Integrating Sphere Test System is suitable for photometric and colorimetric measurement of luminaries such as Energy-saving lamp, Fluorescent lamp, HID lamp (high voltage sodium lamp and high voltage mercury lamp), CCFL and LED. The measured data meets the requirements of

LMS-5000 Quick-Scan Spectrophotometer Colorimeter is a very widely applied single monochromators spectrophotometer with high accuracy. A typical measuring time during the spectral range from 380~800nm is less than 10seconds. LMS-5000 used with right size integrating sphere and standard light source

Specification:
• DIA: IS-0.3M (φ0.3m)、IS-0.5M (φ0.5m)、IS-1.0M (φ1.0m)、IS-1.5M (φ1.5m)、IS-2.0M (φ2.0m). Other size can be designed according request
• Multi interface on the sphere, testing of photometers and colorimeters at the same time.
• Applications: 1. Luminous flux

LPCE-2 is an Integrating Sphere Spectroradiometer LED Testing System for identifying the performance of single LEDs and LED lamp. LED's quality should be tested by checking its photometric, colorimetric and electrical parameters. According to CIE 127-1997 and IES LM 79-08 standards, it recommends to